How to reduce the waste of PC endurance board?

PC hollow polycarbonate board is widely used in all walks of life, especially in the decoration industry, the application is very obvious. The extravagance and waste in the decoration process are very obvious. Here is a tip for everyone. There is a coup to reduce the waste of the board during the use of pc hollow sheet: the process is divided into processing, installation and maintenance. Pay attention to these three processes, you can definitely save materials better and achieve effective use. The following is an analysis for you.

How to reduce the waste of PC endurance board

1. Reduce losses during processing. Nowadays, after many people buy PC solar panels, they must process them to meet the requirements of use. There are three processing methods for sunlight board: vertical method, flat blowing method and upward lead. During the processing, pay attention to the uniform thickness of the film, inflation, traction, gap width, and peripheral width, all of which will cause damage to the solar panel.

2. Reduce losses during installation. In the process of installing the PC sunshine board, you must be very careful, because your own wrong actions may directly cause the board to be scrapped. Therefore, when installing the board, you must be careful to install it to reduce unnecessary losses.

3. Reduce losses during use. As the saying goes, “iron will rust if it is not worn”, and even the best things will be scrapped ahead of time if they are not maintained. Therefore, you must pay attention to maintenance and repair during the use of polycarbonate greenhouse panels. Maybe the warranty is ten years. In your careful maintenance, the life span will be ten months, or one year or even five years. 

Cleaning and maintenance of pc endurance board

1. If there is adhesion of caulking material, grease, paint, and pollution to the surface of the polycarbonate plastic sheets, be sure to remove it with a soft cloth dampened with alcohol before it hardens.

2. Do not use benzene, gasoline, acetone or carbon tetrachloride for cleaning, and avoid cleaning with solvents when exposed to direct sunlight or forced bending, otherwise cracks will occur.

3. The dust and dirt on the surface of the pc endurance board are generally wiped with a soft cloth or sponge dipped in neutral cleaning, then rinsed thoroughly with water, and wiped dry with a soft cloth.

4. The stacked plates cannot be in direct contact with the concrete floor.

5. Avoid placing heavy objects directly on the board, and don't put sharp or hard tools in contact with the board.

6. Do not use alkaline substances or detergents that are incompatible with polycarbonate to clean the board.

7. When the solid polycarbonate sheet area is small, neutral detergent (such as ethanol, ethane, butyl cellulose) can be used, and the board can be scrubbed with a sponge or soft cloth, and then rinsed with water. If the area is large, you can use a high-pressure faucet to rinse the board with clean water.

8. Avoid direct contact between the endurance board and immiscible chemicals.